Navegando por Autor "MOTA, Carlos Alberto Mendes da"

Agora exibindo 1 - 2 de 2

Acesso aberto (Open Access)
Efeitos do comprimento de reversão e do ângulo de ataque sobre a estrutura de solidificação do cordão em soldagem MIG/MAG com "Switch Back"
(Universidade Federal do Pará, 2012-06) ALMEIDA, Hélio Antônio Lameira de; MOTA, Carlos Alberto Mendes da; SCOTTI, Américo
The welding technique denominated switch-back technique consists in a torch oscillation in the welding direction rather than transversally. However, there is not much information in literature about the solidification structure of the bead when this technique is applied. Therefore, in this work is presented a study on the effect of the torch leading angle and of the reversion course length over the bead solidification structure. Welds were carried out with Pulsed MIG/MAG Process on plain carbon steel plates. The results showed that the parameters under analysis modify the solidification mode of the bead. In general, when the angle of torch leads to pushing-pulling movement, equiaxial grains near the fusion line is favored. In relation to the course length, its increase leads to finer solidification structure.
Acesso aberto (Open Access)
Revestimento de níquel depositado pela soldagem MIG e MIG com arame frio
(Universidade Federal do Pará, 2016-12) MOTA, Carlos Alberto Mendes da; NASCIMENTO, Alexandre Saldanha do; GARCIA, Douglas Neves; SILVA, Diego Almir Silva da; TEIXEIRA, Felipe Ribeiro; FERRARESI, Valtair Antônio
This paper presents a study about the operational, geometrical and microstructural characteristics of GMAW and GMAW-CW (GMAW Cold Wire) welds applied on a coating of steel AISI 1020 plate, with a nickel superalloy ER NiCrMo-4, Hastelloy 276C type. The welding was automated in flat position, and executed with an electronic source on DC+ and having instantaneous acquisition of the welding voltage and current oscillograms. The input variables were the speeds of the electrode and cold wires and the welding speed. It was evaluated the operational processes and the effect of heat input on the geometrical characteristics (reinforcement and width), dilution, microstructure and microhardness of the coating. The results indicated a good operating performance, the absence of defects in single passes and in the GMAW-CW coatings. Furthermore, it has been found the lowest level of dilution.